Version 2.1.30 loss of flow measurement tms-200

Koolance TMS Software & Hardware Interface...
Water Pistol Grunt
Water Pistol Grunt
Posts: 3
Joined: Sat Oct 29, 2011 11:35 am

Version 2.1.30 loss of flow measurement tms-200

Postby mramsden » Sat Oct 29, 2011 11:42 am

I was getting the loud alarm on cold boot issue, so upgraded from 2.1.25 to 2.1.30 f16 version.

Upgrade seemed to go ok, and everything is working, but I don't get any flow indication from the FM-16 flowmeters, which did work with the previous version.

When I try to run the pump characteristics, get no indication.

The pumps are running: I can see the water flowing and the vanes in the flowmeters spinning, and I do get all of the temp readings (8 channels) and the fan readings are working properly.

I tried a cold reboot after a couple of restarts, and unfortunately still have the alarm sounding until the software loads .... but the flowmeters aren't showing anything.


Thanks ..


Return to “Software”

Who is online

Users browsing this forum: No registered users and 1 guest