Northbridge, Southbridge, PCI-E chip, and VReg water blocks...
1 post • Page 1 of 1
- Water Pistol Grunt
- Posts: 2
- Joined: Wed Apr 11, 2012 10:35 pm
I'm trying to install the Koolance MOSFET water block for my Asus Sabertooth X79 mobo. I'm having a issue with the back plate that came with the waterblock. My question is that do i tight the two screws all the way down or just enough pressure? if i tight the two screws all the way down than the back plate will bent and having an ark. So do i tight it just right and make sure the plate stay flat?
Users browsing this forum: No registered users and 1 guest