I recently installed the two water blocks for R4E,
reason why I bought it in the first place, is the VRM throttling me when I am on full load at 1.5Vs whenever clocking into the 4.8-5.1Ghz area.
I installed the block, and went straight to prime95 to test...
same throttling happened.
luckily is that if I point a fan at it, I can solve it.. however, that defeats my purpose of having the block in the first place...
I wonder did I overlook anything in the installation?
I made no stupid mistakes like forgetting to remove the plastic on the thermal pads etc..
just not sure why I ain't getting the VRMs cool...
any input will be welcomed.
here's a pic of my block after installation.
http://www.overclockers.com/forums/atta ... 1338105138
Northbridge, Southbridge, PCI-E chip, and VReg water blocks...
1 post • Page 1 of 1
Users browsing this forum: No registered users and 3 guests