Page 1 of 1

How to mount the PMP 420?

Posted: Wed Jul 13, 2016 4:29 pm
by jcanady20
The PMP-420 comes with a very simply mount. However the holes don't seem to match with standard morning points.
Was I supposed to purchase a separate mount? Or is there a mount/bracket I'm supposed to use?

Re: How to mount the PMP 420?

Posted: Fri Jul 15, 2016 8:32 am
by Izerous
Pull out a drill and make 4 appropriate holes. Cover holes with a touch of paint to prevent rusting if not aluminum/plastic and mount it where you want it. If you can find them in the right size rubber isolation mounts will help reduce vibration transfer.

Edit: Here is an example of an isolation mount https://www.grainger.com/product/GRAINGER-APPROVED-Vibration-Isolator-2NPE1?s_pp=false&picUrl=//static.grainger.com/rp/s/is/image/Grainger/2NPE5_AS01?$smthumb$