Like the subject says the tms software shows no change in flow or rpm in any voltage setting s for both 450 pumps in a RP-452X2.
the rpm is always 4800 no matter what voltage.
Seemed simple enough to hook the pumps up only two connectors to use and they were plugged into tms 200 and addon board and theother connectors to 12v psu connectors.
thanks for any help.
Software shows no rpm or flow change for 450 pumps
-
- Water Pistol Grunt
- Posts: 3
- Joined: Sat May 28, 2011 6:47 pm
-
- Water Pistol Grunt
- Posts: 3
- Joined: Sat May 28, 2011 6:47 pm
Re: Software shows no rpm or flow change for 450 pumps
Nevermind
By the time this post was allowed I came across on another forum what my problem is I think.
If I am correct I need to put all three wires into the connector that goes into the tms boards.
It would be nice if some of these parts came with better or at least some instructions.
By the time this post was allowed I came across on another forum what my problem is I think.
If I am correct I need to put all three wires into the connector that goes into the tms boards.
It would be nice if some of these parts came with better or at least some instructions.
Who is online
Users browsing this forum: No registered users and 0 guests